Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
920
CUTTING CONDITIONS 2
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
CUT POINT Z = Position of cut end point . . . . . . . . . . .
(mm or inch)
(When bit 7 of system parameter
702 is 1)
or
DEPTH OF CUT D = Depth of cut (mm or inch). . . . . . .
(When bit 7 of system parameter
702 is 0)
DEPTH OF CUT D1 = Primary drilling depth . . . . . . .
(mm or inch)
RETURN AMOUNT U = Amount of return (mm or inch). . . .
SPINDLE ROTATION N = Spindle rotation speed (rpm). . .
FEED RATE F1 = Feed rate (mm/rev or inch/rev). . . . . . . . . . .
CUTTING CONDITIONS 3
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
CLEARANCE C1 = Secondary drilling clearance. . . . . . . . .
CUT POINT Z = Position of cut end point (mm or. . . . . . . . . . .
inch)
(When bit 7 of system parameter
702 is 1)
or
DEPTH OF CUT D = Depth of cut (mm or inch). . . . . . .
(When bit 7 of system parameter
702 is 0)
DEPTH OF CUT D1 = Primary drilling depth . . . . . . .
(mm or inch)
DEPTH OF CUT D2 = Secondary drilling depth . . . . . . .
(mm or inch)
RETURN AMOUNT U = Amount of return (mm or inch). . . .
SPINDLE ROTATION N = Spindle rotation speed (rpm). . .

Leave a Reply

Your email address will not be published. Required fields are marked *