Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
921
FEED RATE F1 = Feed rate (mm/rev or inch/rev). . . . . . . . . . .
FEED RATE F2 = Feed rate for second pass . . . . . . . . . . .
(mm/rev or inch/rev)
CAUTION
D1 and D2 in Machining method 2 and Machining method
3
As shown in figure 7 and figure 8, “D1” and “D2” in
machining method 2 and machining method 3 are input as
positive values.
#7
702
#6 #5 #4 #3 #2 #1 #0
Bit 7 Specification of depth of cut
0 : Specifies with an incremental value
1 : Specifies with an absolute value
Associated parameter

Leave a Reply

Your email address will not be published. Required fields are marked *