Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
925
(11) Grooving/necking machining conditions
PECKING ON/OFF PE = Yes/No of pecking 1 machining . . . . .
(Yes = 1, No = 0)
DEPTH OF CUT D = Cutting amount per cutting on. . . . . . .
pecking 1 machining
(mm or inch)
RETURN AMOUNT U = Return escape amount per cutting. . . .
on pecking 1 machining
(mm or inch)
CLEARANCE C = Clearance amount (mm or inch). . . . . . . . .
FINISH ALLOWANCE TW = Finish amount in width direction. .
(mm or inch)
TB = Finish amount in depth direction
(mm or inch)
CUTTING SPEED V = Cutting feed rate . . . . . .
(m/min or feet/min)
FEED RATE F1 = Rough machining feed rate . . . . . . . . . . .
(mm/rev or inch/rev)
F2 = Finish machining feed rate
(mm/rev or inch/rev)
MAX RPM N = Maximum spindle speed (rpm). . . . . . . . . . . .
(CAUTION 2)
Pecking machining operation
The pecking operation on grooving rough machining is as follows:

Leave a Reply

Your email address will not be published. Required fields are marked *