Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
927
(a) Parameter
(i) System parameter No.104 (Initial value = 0)
#7 #6 #5 #4 #3 #2 #1 #0
Bit 1 Designation of 1st override value question skipping for 1st override value
for outside diameter roughing depth of cut
0 : Skip
1 : No skip
(ii)System parameter No.711 (Initial value = 100)
Set the 1st override for outside diameter roughing depth of cut.
Not defined: 100%
n: n%
CAUTION
However, the override setting is up to 10 to 100%.
When other values than this range are set, the override
value is 100%.
(b)Explanation of operation
(i) When skipping the question on the override value:
Set bit 1 of system parameter No.104 to 0 and the override value
to No.711.
In this setting, the system does not ask the override value on the
cutting condition screen for the outside diameter roughing
definition but with the system parameter No.711 value as the
override value, the 1st override processing for outside diameter
roughing is carried out automatically.
(ii)When no skipping the question on the override value:
Set bit 1 of system parameter No.104 to 1: the system asks the
following on the cutting condition screen for the outside
diameter roughing definition.
1st override ... % =
NOTE
For “New”, the system parameter No.711 value is set as the
initial value.
For “Modifications”, the value set so far is displayed.
Answer this question, key in the override value.
When the value on the display is acceptable, key in “INPUT”
only.
NOTE
Even when the 1st override value for outside diameter
roughing depth of cut is changed, the system parameter
No.711 value remains unchanged.

Leave a Reply

Your email address will not be published. Required fields are marked *