Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
930
(5)Designation of cutting of residual pocket
A pocket may be produced, depending upon parts figure and tool figure
as illustrated above. In such a case, designate the area to cut such a pocket
only by using a reversible tool.
It should be carefully noted that if a reversed tool is not properly
positioned or if tool figure data is not appropriate, the pocket area cannot
always be input.
After the cutting area has been designated, the designated cutting area is
lathed out from the blank figure by the tool. The, the system asks you to
check if another portion is to be cut by the same tool or not.
CUTTING ANOTHER AREA
BY SAME TOOL? CN = . . .
(1: YES 0: NO)

Leave a Reply

Your email address will not be published. Required fields are marked *