Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
931
Answer this question by one of the following operations.
In case of “YES”.. . .
(Another position is cut by the same tool)
In case of “NO”. . . .
(Not cut by the same tool)
After answering all questions, the CRT screen returns to the process list
which asks you the kind of machining.
If you want to prepare NC data after defining the kind of machining,
depress [NEXT PAGE] key in response to the system question about the
kind of machining.
[NEXT PAGE]
When the system parameter No.140 is defined as Definition for cut off
machining, on the screen which defines the type of machining, by
displaying as cut off, the cut off machining can be selected.
Fig. B.1.2.1 (a)
Input the tool data. Use the grooving tool.
CAUTION
When defining cut off machining tool, set the data so that the
cutting direction is in the minus X axis direction.
B.1.2
Cut off Machining, Bar
Feed
B.1.2.1
Cut off machining
Setting of tool data
1
INPUT
0
INPUT

Leave a Reply

Your email address will not be published. Required fields are marked *