Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
932
Fig. B.1.2.1 (b)
CLEARANCE C1 = . (mm or inch). . . . . . . . . . . . . . .
Specify the clearance in X axis direction from the blank figure.
FINISH ALLOWANCE: TZ = . (mm or inch). . . . . . .
Specify the finish allowance at the parts side during cutting–off
operation.
CUT OFF POS: CO = . (mm or inch). . . . . . . . . . . . . .
Specify the cutoff position with the work inner diameter or the
distance from the work center.
COND.RESET POS: CR = . (mm or inch). . . . . . . . . .
Specify the position for changing the machining conditions with the
distance from the cutoff position.
RETURN AMOUNT: RA = . (mm or inch). . . . . . . . .
Specify the pullout amount of a tool in X axis direction from the
machining condition change position.
CUTTING SPEED: V1 = . (m/min or feet/min) . . . . . . . . . . .
V2 = . (m/min or feet/min)
FEED RATE: F1 = . (mm/rev or inch/rev). . . . . . . . . . . . . . . .
V2 = . (mm/rev or inch/rev)
Definition of cutting
conditions

Leave a Reply

Your email address will not be published. Required fields are marked *