Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
933
Designate the cutting speed for a b and b c in Fig. B.1.2.1 (c) below
with V1, the feed rate with F1, c d cutting speed with V2 and the
feedrate with F2.
Fig. B.1.2.1 (c)
The value of CO, CR, RA is designated in system parameter as Number
141, 142 and 143 respectively.
Fig. B.1.2.1 (d)
Definition of cutting start
position

Leave a Reply

Your email address will not be published. Required fields are marked *