Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
934
STARTING POINT OF CUTTING OFF: SP
Designate the cuttingoff start position, using the cursor on the screen.
The cursor moves every time soft keys “CURSOR ° and “CURSOR ±
are depressed.
The cursor moves forward or backward along the parts figure. If the
cutting start position is designated, using the cursor, press “INPUT” key
or soft key NEXT PAGE, and define its point as the cutting start
position.
The cursor just after this screen is displayed is blinking where
X–coordinate value on the figure element at the leftmost side of part
figure is maximum. The tool path for cutting off when the cutting start
position is designated at this point is illustrated below. (Fig. B.1.2.1 (e))
Fig. B.1.2.1 (e)
Further, the cutting path when one previous element figure is designated
as the cutting start position with the cursor moved is illustrated below.
(Fig. B.1.2.1 (f))
Fig. B.1.2.1 (f)

Leave a Reply

Your email address will not be published. Required fields are marked *