Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
935
Designate the chamfering of outer diameter at the cutoff (blank) side,
using system parameter No.144. When the blank side chamfering is
designated, the blank side chamfer is inserted after cuttingoff. (Fig.
B.1.2.1 (g))
Fig. B.1.2.1 (g)
(1)On the KINDS OF MACHINING screen, press TURN to display the
software keys for defining the bar feed process.
(2)The bar feed amount is the distance between the work edge left after
cutting–off and the work edge defined by the blank figure. This
amount is automatically calculated by the system.
Work end face after cutting off
Fig. B.1.2.2 (a)
B.1.2.2
Bar feed

Leave a Reply

Your email address will not be published. Required fields are marked *