Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
937
(1)Pull–out method 1
Clearance CAZ=approach clearance (mm). . . . .
Grip position WG =work grip position (mm). . .
Recess amount CEZ=tool recess amount (mm).
Feed rate F1 = feed rate (for gripping) (mm/min). . . . . .
F2 = feed rate (for pulling or positioning)
(mm/min)
F3 = feed rate (for relief) (mm/min)
(2)Pull–out method 2
Clearance CAX=approach clearance (mm). . . . .
Grip position WG =work grip position (mm). . .
Feed rate F1 = feed rate (for gripping) (mm/min). . . . . .
F2 = feed rate (for pulling or positioning)
(mm/min)
F3 = feed rate (for relief) (mm/min)

Leave a Reply

Your email address will not be published. Required fields are marked *