Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
940
NOTE
1 The turret number prompt is displayed if there are more than
1 tool rests. The number of tool rests is to be set in
No.MTF1050.
2 The tool ID number (ID) to be input must have been
registered in tool data. If a tool ID number (ID) not registered
in tool data is input, a message This ID is not registered in
tool data. is displayed. Also if a tool ID number having a tool
type not compatible with the present process is input, a
messageThe tool type of this ID is not compatible with the
present process. is displayed. The registered tool ID
number is deleted from the tooling information if keyed in as
“DEL” “INPUT”.
When using a tool which has already been registered in the tooling
information, the other data is automatically displayed if the tool selection
number (TN) is input.
In new registration, the data of the tool configuration and that of setting
which have been registered in the tool data are displayed if the tool ID
number (ID) is input.
(Center Drill)
TOOL TYPE TP; Caxis center drill
TOOL MATERIAL MT;
TOOL DIAMETER DT;
CUT WIDTH DS;
CUT LENGTH LT;
NOSE ANGLE AT;
(Drill)
TOOL TYPE TP; Caxis drill
TOOL MATERIAL MT;
TOOL DIAMETER DT;
CUT LENGTH LT;
NOSE ANGLE AT;
(Tap)
TOOL TYPE TP; Caxis Tap
TOOL MATERIAL MT;
TOOL DIAMETER DT;
CUT LENGTH LT;
PECK LENGTH LE;
PITCH PT;
(End mill)
TOOL TYPE TP; Caxis End mill
TOOL MATERIAL MT;
TOOL DIAMETER DT;
CUT WIDTH DS;
CUT LENGTH LT;
CUT COUNT NT;

Leave a Reply

Your email address will not be published. Required fields are marked *