Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
941
Prompts on data of setting (Settable/Alterable)
SETTING DIRECTION CP = (0: Side machining, . . . . .
1: End machining)
SETTING POSITION XS = . . . . . .
ZS =
ROTATE DIRECTION TR = (0: Forwards, 1: Backwards). . . . . .
HOLDER NO. HL = . . . . . . . . . . . .
(NOTE)
NOTE
The holer number (HL) prompt is displayed if the optional
animation drawing function is available.
3) Machining start position
When all tool data are input, the screen asks the machining start
position.
MACHINING START POSITION
X coordinate values DXO =. . . . . .
Z coordinate values ZO =. . . . . .
4) Cutting conditions for Caxis machining
The cutting conditions required for a particular type of machining are
requested according to the type of machining selected.
(a) Center sink conditions
RPM N = Tool speed (rpm). . . . . . . . . . . . . . .
FEED RATE FT = Feed amount per tool revolution. . . . . . . .
(mm/rev)
DEPTH OF CUT D1 = Infeed amount (mm). . . . .
CLEARANCE C1 = Clearance quantity 1 (mm). . . . . . .
(b)Drilling conditions (Machining method 1)
RPM N. . . . . . . . . . . . . . .
Tool speed (rpm)
FEED RATE FT = Feed amount per tool revolution. . . . . . . .
(mm/rev)
DWELL ON/OFF DW =1 with dwell at hole bottom, 0. . . .
without dwell
CLEARANCE C1 = Clearance quantity 1 (mm). . . . . . .
CLEARANCE C2 = Clearance quantity 2 (mm). . . . . . .
(c) Drilling conditions (Machining method 2)
RPM N = Tool speed (rpm). . . . . . . . . . . . . . .
FEED RATE FT = Feed amount per tool revolution . . . . . . . .
(mm/rev)
CLEARANCE C1 = Clearance quantity 1 (mm). . . . . . .
CLEARANCE C2 = Clearance quantity 2 (mm). . . . . . .
DEPTH OF CUT D1 = Infeed amount (mm). . . . .
RETURN AMOUNT U = Return amount (mm). .

Leave a Reply

Your email address will not be published. Required fields are marked *