Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
947
(1)The blind hole and through hole settings
The blind hole and through hole settings in the C axis component
shape definition are only used in tapping machining. All other hole
machining is restricted to through holes.
(2)Details of blind hole and through hole settings
The effects of blind hole and through hole settings are shown below
for different hole machining processes.
Indicates the position of the tip of the tool.
(1) Center sink machining (2) Drilling
(3) Blind hole tapping (4) Through hole tapping
The tool stops with a clearance of C2
before the depth of the hole.
B.1.3.3
Blind hole and through
hole

Leave a Reply

Your email address will not be published. Required fields are marked *