Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
949
(2)Press the “AUTO” and then the PROCESS SETTING screen is
displayed. The data being displayed at this point includes the
machining method group number (No.000) and the description of
machining procedure data of that group (No.100 130, No.200 230,
No.300 330).
If the machining method group number of setting data is undefined at
this time, the machining procedure data of group number set by blank
figure is displayed.
(3)Press the software key “EXEC” if the machining method group and
machining procedure data displayed on the screen are proper.
(4)Input the machining group number for the MG = question when
modifying the machining method group.
(5)Move the cursor by the software key “CURSOR to modify the
description of machining procedure data when modifying the
description of machining procedure data.
The meaning of software key used for modifying operation is as follows:
[CURSOR °] [CURSOR ±] Set the cursor to the position where. .
machining procedure is deleted or
inserted.
[PROC DELETE] It deletes the process where the cursor is. . . . . . . . .
blinking.
[INSERT] Insert a new process before the process. . . . . . . . . . . . . . . .
where a cursor is blinking.
i) When this software key is pressed, the software key for setting the
type of process appears.
ii) The software key for setting the type of process changes cyclicly
by pressing the software key
”.
iii)Press the software key of process type inserted to allow a new
process to be inserted.
iv) Press the software key
to allow the insertion mode to be
released.

Leave a Reply

Your email address will not be published. Required fields are marked *