Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
77
c) To specify the copy end point, align the cursor to the copy and point
with the CURSOR FORWRD, CURSOR BACK key and press
the INPUT key.
When the copy end point has been specified, the message “SPECIFY
THE COPY START POINT will appear.
d) When the soft key “EXEC” is pressed, the figure element will be
copied repeatedly within the range specified by the copy start point and
copy end point. Note however that when the number of repeats has not
been defined, the message KEY IN REPEAT NO. will appear and
the “EXEC” key should be pressed after having entered the number of
repeats.
Example) Illustration type = 2
Blank figure BF = 1
Blank dimensions
Diameter D = 100
Length L = 105
Position of reference line ZP = 5
Number 1 element ± SDX = 0 SZ = 0 PE =1
DX = 20
Number 2 element ² Z = 10
Number 3 element ¾ DX = Undefined Z = Undefined TN = 0
A = 45
Number 4 element ² Z = 30 Z = 20 TN = 0
Number 5 element ± DX = 20
Number 6 element ² Z = 25
Number 7 element ° DX = 40
Number 8 element ² Z = 30
Number 9 element
The following explanation is based on an example where the above
mentioned data has been defined and one copy is required from No.3
element to No.8 element.
By pressing the soft key ELEMENT COPY, the copy area specification
screen will be displayed, set the repeat number to 1 and specify the No.3
element at copy start point and No.8 element at the copy end point.

Leave a Reply

Your email address will not be published. Required fields are marked *