Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
952
Preset the data used in automatic process specification, via the setting
screen. To display the setting screen, first press the DATA SET soft key,
and then key in 2 “INPUT”.
(1)Machining order data (100 129, 200 229, 300 329)
Set data to indicate what order the machining is to be done.
The setting of the machining process is done with numbers. The
numbers and the machining processes correspond as follows:
1. CENTER DRILLING
2. DRILLING
3. ROUGH FACING
4. ROUGHING OF OUTER FIGURE
5. ROUGHING OF INNER FIGURE
6. SEMIFINISHING FACING
7. SEMIFINISHING OF OUTER FIGURE
8. SEMIFINISHING OF INNER FIGURE
9. FINISHING FACING
10. FINISHING OF OUTER FIGURE
11. FINISHING OF INNER FIGURE
12. GROOVING FACING
13. GROOVING OF OUTER FIGURE
14. GROOVING OF INNER FIGURE
15. NECKING OF OUTER FIGURE
16. NECKING OF INNER GIGURE
17. THREADING FACING
18. THREADING OF OUTER FIGURE
19. THREADING OF INNER FIGURE
Above are turning processes.
20 to 29 are not used.
30. FACE CENTER DRILLING
31. SIDE CENTER DRILLING
32. FACE DRILLING
33. SIDE DRILLING
34. FACE TAPPING
35. SIDE TAPPING
36. CAXIS FACE GROOVING
37. CAXIS SIDE GROOVING
Above are Caxis machining.
FAPT performs automatic specification of machining process according
to the order set here. Machining processes not set here cannot
automatically be prepared.
B.2.3
Setting
B.2.3.1
Setting data

Leave a Reply

Your email address will not be published. Required fields are marked *