Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
954
(2)Manual input flag data (Nos.130 166, 230 266, 330 366)
These data will have no meaning unless the machining process is set
in the machining procedure data.
#7 #6 #5 #4 #3
MPP
#2
MCD
#1
MCC
#0
MTS
MTS Set whether or not to perform manual tool selection
1 : Tool selection is done manually.
The automatic proceeding of the tool data question screen will halt, so
tool number must be input manually.
0 : Tool selection is done automatically.
The appropriate tool will be selected from the tooling information.
MCC Set whether or not to manually input cutting conditions.
1 : Cutting conditions are input manually.
The automatic proceeding of cutting conditions question screen will
halt, so input cutting conditions manually.
0 : Cutting conditions are set automatically.
MCD Set whether or not to manually set cutting direction and area.
1 : Cutting direction and area are set manually.
0 : Cutting direction and area are decided automatically.
MPP Set whether or not to input the passing point manually
1 : Automatic processing of the passing point screen will halt, so passing
point can be input manually.
0 : Processings are automatically prepared without the passing point
defined.

Leave a Reply

Your email address will not be published. Required fields are marked *