Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
959
CAUTION
Finishing of Outer Figure
If machining processes are set in the machining procedure
data in the order of FINISHING FACING and “FINISHING
OF OUTER FIGURE, the outer diameter part is cut by using
the same tool after cutting the end face from the outside to
the center as shown in Fig. B.2.4 (a) when there exists no
inner diameter part.
When an inner diameter part exists, cutting is done
continuously at the end face part through outer diameter
part as shown in Fig. B.2.4 (b)
Fig. B.2.4 (a) Fig. B.2.4 (b)
CAUTION
If the pocket machining leaves some remainder, tool is
automatically changed, and the remainder will not be cut.
The remainder must be cut later, preparing the machining
process manually by monitoring the screen.

Leave a Reply

Your email address will not be published. Required fields are marked *