Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
960
NOTE
1 Multiple neckings and threadings can be done, if the same
tool is used.
2 In necking, (a) and (b) of the following figure can be
machined, but (c) or (d) where back handed tools are
required, cannot be machined. In these cases, add
machining process manually, after automatic machining
process decision.
Fig. B.2.4 (c)
NOTE
Cannot be used for chaser turret.
CAUTION
If a center drilling process is set as a machining procedure
data, a center drilling process is always prepared
irrespective of the part shape. However, the center drilling
process is not generated, if the center drilling tool is not
loaded into tooling data, even if center drilling is included in
Machining procedure data of setting data. When the
center drilling process is not required, do not set a center
drilling process on the machining procedure data. Or delete
the center drilling process as required after preparing all the
processes.

Leave a Reply

Your email address will not be published. Required fields are marked *