Fanuc Symbol CAPi T Operators Manual

INDEX
B–63304EN/02
i–3
Interference check in approach and return relief, 336
ƠJơ
Judgement of pockets, 369
ƠKơ
Keys effective in FAPT mode, 16
Kind of Caxis machining specification, 430
Kind of machining, 408
ƠMơ
Machine tool file (MTF) table, 845
Machine zero point and turret position, 84
Machine zero point/turret turning position (menu no. 3), 779
Machining definition, 85, 493, 747
Machining definition (menu 4), 429, 505
Machining definition (menu no. 4), 780
Machining definition (menu No.4), 609
Machining definition for 5700 series, 906
Machining definition menu, 555
Machining definition of Caxis machining, 938
Machining definition of turning, 906
Machining for which automatic process determination cannot
be used, 662
Machining start position, 97, 433, 915
Machining time display screen, 684
Main memory, 215
Main memory and submemory, 214
Material and tool data, 452
Material data, 239, 453
Material data and material file, 240
Material data input (menu No.1), 607
Maximum number of tools, 713
Memory composition, 213
Method of deletion, 244
Method of modification, 243
Method of registration, 242
Method of stopping the tool on Z axis, 403
Method of using the same tool for separate machining types
where tool axis slant angles are different, 788
Milling, 529
Milling in multiple planes, 425
Modifying a defined process, 630
MTF, 459, 487, 495, 616, 765
MTF Parameters, 519
MTF parameters, 690
MTF setting, 348
MTF setting when Caxis FAPT function is used, 460
Multitier drilling (B option for the automatic process
determination function), 648
ƠNơ
NC data, 198
NC data creation, 510
NC data format, 327
NC data output, 464
NC data output by single step, 317
NC data preparation, 137, 682, 759
NC data preparation (menu No.5), 612
NC machine files (MTF), 802
NC machine tool file (MTF), 587
No. of files registerable in submemory, 217
Notes on material files, 245
Notes on reading this manual, 6
ƠOơ
Operating instructions, 160, 745
Operation, 207, 716, 947
Operation method, 242
Operation procedure for animated simulation, 696
Outline, 189, 744
Output function for interpolation rigid tapping, 355
Output in main program and subprogram format, 322
Output of NC data, 185
Output of only single process, 91, 910
Output/input and collation, 292
Outputting comments to NC data, 792
Outputting data about the tool clamping type (normal or
reverse), 795
Outputting NC data in the FS15T/16T format, 348
Outputting the NC data of a multiple thread cutting cycle, 152
Outputting the spindle number, 794
Outputting the tool angular axis angle, 793
ƠPơ
“P” key , 731
Parameter, 233
Parameter screen for animated simulation, 451
Parameters, 518, 717, 764
Parameters, etc., 614
Part figure definition, 504
Part figure definition (menu 2), 407, 532
Part figure input (directory input system), 60
Part figure input (input method of with figure), 39
Part figure input (menu No.2), 607

Leave a Reply

Your email address will not be published. Required fields are marked *