Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
79
NOTE
1 The final element of the figure must be a direction arrow and
the end point defined, before pressing the FIGURE COPY
key.
Examples:
Figure element number 1 2 3 4 5 6 7 8. . . . . . .
Figure configuration element ° ²¾² ±² °²j. . .
°
The element here must be
an direction arrow and the
end point defined.
a) When the element in front is not a direction arrow, if the
soft key FIGURE COPY is pressed, the error message
LAST END POINT IS ARROW will be displayed and the
copy specification screen will not appear.
b) When the end point of the element is not defined, if the
soft key FIGURE COPY is pressed, the error message
LAST END POINT IS UNDEFINED will be displayed
and the copy specification screen will not appear.
2 Input a positive whole number between 1 and 10 in the
repeat number. If any other data is keyed in the message
KEY IN AGAIN will appear.
3 When there is incremental type data in the copy area, it will
change to absolute type data when copied.
4 When the general element number has been exceeded
during execution of figure copy, as many copies as is
possible will be created. An error message indicating that
the number of element is excessive will appear on the
screen.

Leave a Reply

Your email address will not be published. Required fields are marked *