GE Fanuc Series 16/18/160/180 – Model C Hardware Connection Manual

The following figure shows the configuration of the electrical system of the machine tool with which this control is used. This manual describes how to connect the units illustrated in this diagram. The machine tool body, machine operator’s panel, power magnetic circuit, and sensor/actuator are specific to the machine tool and are the builder’s responsibility. This manual does not cover the internal connection of these units to the machine tool. The numbers in parentheses shown in the diagram are section references for this manual.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>