PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
97
P8E Editing of subprograms 80000000 to 89999999 is:
0 : Not inhibited
1 : Inhibited
The following editing types become impossible.
(1) Program deletion (Programs numbered in the 80000000 range will
not be deleted even if allprogram deletion is specified.)
(2) Program output (Programs numbered in the 80000000 range will not
be output even if allprogram output specified.)
(3) Program search by number
(4) Program editing after registration
(5) Program registration
(6) Program collation
(7) Program display
P9E Editing of subprograms 90000000 to 99999999 are:
0 : Not inhibited
1 : Inhibited
The following editing types become impossible.
(1) Program deletion (Programs numbered in the 90000000 range will
not be deleted even if allprogram deletion is specified.)
(2) Program output (Programs numbered in the 90000000 range will not
be output even if allprogram output specified.)
(3) Program search by number
(4) Program editing after registration
(5) Program registration
(6) Program collation
(7) Program display
SPR Program numbers in the 9000 range for specific programs are:
0 : Not added with 90000000
1 : Added with 90000000
[Example]
The program numbers for G codes used to call custom macros are as
follows:
SPR = 0: 00009010 to 00009019
SPR = 1: 90009010 to 90009019
Subprogram numbers 9500 to 9510 used by the pattern data input function
are as follows:
SPR = 0: 00009500 to 00009510
SPR = 1: 90009500 to 90009510
MKP When M02, M30, or EOR(%) is executed during MDI operation, the
created MDI program is:
0 : Erased automatically.
1 : Not erased automatically.
NOTE
If the MER parameter (bit 6 of parameter No.3203) is 1,
executing the last block provides a choice of whether to
automatically erase a created program.

Leave a Reply

Your email address will not be published. Required fields are marked *