PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
101
#7
3403
#6
AD2
#5
CIR
#4 #3 #2 #1 #0
[Data type] Bit
CIR When neither the distance (I, J, K) from a start point to the center nor an arc
radius (R) is specified in circular interpolation (G02, G03):
0 : The tool moves to an end point by linear interpolation.
1 : P/S alarm No.022 is issued.
AD2 Specification of the same address two or more times in a block is:
0 : Enabled
1 : Disabled (P/S alarm No.5074)
NOTE
1 When 1 is set, specifying two or more G codes of the same
group in a block will also result in an alarm being issued.
2 If the M3B parameter (bit 7 of parameter No. 3404) is 1, up
to five and three M codes can be specified, respectively, for
the Power Mate iH and Power Mate iD.
#7
M3B3404
#6
EOR
#5
M02
#4
M30
#3 #2 #1
POL
#0
NOP
[Data type] Bit
NOP When a program is executed, a block consisting of an O number, EOB, or
N number is:
0 : Not ignored, but regarded as being one block.
1 : Ignored.
POL For a command address allowing a decimal point, omission of the decimal
point is:
0 : Enabled
1 : Disabled (P/S alarm No.5073)
M30 When M30 is specified in a auto operation:
0 : M30 is sent to the machine, and the head of the program is
automatically searched for. So, when the ready signal FIN is returned
and a reset or reset and rewind operation is not performed, the
program is executed, starting from the beginning.
1 : M30 is sent to the machine, but the head of the program is not searched
for. (The head of the program is searched for by the reset and rewind
signal.)
M02 When M02 is specified in auto operation
0 : M02 is sent to the machine, and the head of the program is automati-
cally searched for. So, when the end signal FIN is returned and a reset
or reset and rewind operation is not performed, the program is
executed, starting from the beginning.
1 : M02 is sent to the machine, but the head of the program is not searched
for. (The head of the program is searched for by the reset and rewind
signal.)

Leave a Reply

Your email address will not be published. Required fields are marked *