PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
102
EOR When the endofrecord mark (%) is read during program execution:
0 : P/S alarm No.5010 occurs. (Automatic operation is stopped, and the
system enters the alarm state.)
1 : No alarm occurs. (Automatic operation is stopped, and the system is
reset.)
M3B The number of M codes that can be specified in one block
0 : One
1 : Up to fire (Up to thee for Power Mate iD)
#7
3406
#6 #5
C05
C05
#4 #3
C03
C03
#2
C02
C02
#1
C01
C01
#0
3407
C13
C13
C09
C09
C08
C08
CFH
3409
CFH
[Data type] Bit
Cxx (xx: 01 to 13) When bit 6 (CLR) of parameter No.3402 is 1, the reset button on the MDI
panel, the external reset signal, the reset and rewind signal, or emergency
stop will,
0 : Clear the G code with group number xx.
1 : Not clear the G code with group number xx.
CFH When bit 6 (CLR) of parameter No.3402 is 1, the reset button on the MDI
panel, the external reset signal, the reset and rewind signal, or emergency
stop will,
0 : Clear F codes, H codes, D codes, and T codes.
1 : Not clear F codes, H codes, D codes, and T codes.
3410 Tolerance of arc radius
[Data type] 2word
[Unit of data]
Increment system ISA ISB ISC Unit
Millimeter input 0.01 0.001 0.0001 mm
Inch input 0.001 0.0001 0.00001 inch
[Valid data range] 1 to 99999999
When a circular interpolation command (G02, G03) is executed, the
tolerance for the radius between the start point and the end point is set. If
the difference of radii between the start point and the end point exceeds the
tolerance set here, a P/S alarm No.20 is informed.
NOTE
When the set value is 0, the difference of radii is not checked.

Leave a Reply

Your email address will not be published. Required fields are marked *