PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
104
3620
Number of the pitch error compensation position for the reference position for
each axis
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
[Data type] Word axis
[Unit of data] Number
[Valid data range] 0 to 1023
Set the number of the pitch error compensation position for the reference
position for each axis.
3
2
1
1
2
Pitch error compensation value (absolute value)
Reference position
Pitch error compensation
position (number)
Compensation position number
Set compensating value
31 32 33 34 35 36 37
+3 1 1+1+21 3
Fig.4.16 Pitch Error Compensation Position Number and Value (Example)
In the above example, set 33 as the number of the pitch error
compensation position for the reference position.
3621
Number of the pitch error compensation position at extremely negative position
for each axis
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
[Data type] Word axis
[Unit of data] Number
[Valid data range] 0 to 1023
Set the number of the pitch error compensation position at the extremely
negative position for each axis.
4.16
PARAMETERS OF
PITCH ERROR
COMPENSATION
(OPTIONAL
FUNCTION WITH
POWER MATE iH)

Leave a Reply

Your email address will not be published. Required fields are marked *