PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
127
#7
5001
#6
EVO
#5 #4 #3
TAL
#2 #1
TLB
#0
TLC
[Data type] Bit type
TLC Tool length compensation
0 : Tool length compensation A or B (Conforms to TLB in parameter
No.5001)
1 : Tool length compensation C
TLB Tool length compensation axis
0 : Always Z axis irrespective of plane specification (Tool length
compensation A)
1 : Axis perpendicular to plane specification (G17, G18, and G19) (Tool
length compensation B)
TAL Tool length compensation C
0 : Generates an alarm when two or more axes are offset
1 : Not generate an alarm even if two or more axes are offset
EVO Specifies whether an offset is effective in the next block to be buffered or
the next block for which an H code is specified when the offset value is
changed in tool length offset A or B.
0 : Next block in which an H code is specified.
1 : Next block to be buffered.
#7
5003
#6
LVK
#5 #4 #3 #2 #1 #0
[Data type] Bit
LVK Tool length offset value
0 : Cleared by reset
1 : Not cleared, but held by reset
4.18
PARAMETERS OF
TOOL
COMPENSATION

Leave a Reply

Your email address will not be published. Required fields are marked *