PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
128
#7
M5B
5101
#6
M5T
#5
RD2
#4
RD1
#3 #2 #1 #0
FXY
[Data type] Bit
FXY The drilling axis in the drilling canned cycle is:
0 : Always the firstaxis
1 : The axis selected by the program
RD2, RD1 Set the axis and direction in which the tool in drilling canned cycle G76 or
G87 is got free. RD2 and RD1 are set as shown below by plane selection.
RD2 RD1 G17 G18 G19
0 0 +X +Z +Y
0 1 X Z Y
1 0 +Y +X +Z
1 1 Y X Z
M5T When a spindle rotates from the forward to the reverse direction and vice
versa in tapping cycles G84 and G74 for M series, before M04 or M03 is
output:
0 : Outputs M05
1 : Not output M05
M5B In drilling canned cycles G76 and G87:
0 : Outputs M05 before an oriented spindle stops
1 : Not output M05 before an oriented spindle stops
#7
5103
#6 #5 #4 #3 #2 #1
QZA
#0
[Data type] Bit
QZA When the specification of the depth of cut (Q) for each time is omitted, or
if Q0 is specified in a highspeed peck drilling canned cycle (G73) or peck
drilling canned cycle (G83):
0 : No alarm is issued.
1 : An alarm (No.045) is issued.
4.19
PARAMETERS OF
CANNED CYCLES
4.19.1
Parameter of canned
Cycle for Drilling

Leave a Reply

Your email address will not be published. Required fields are marked *