PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
130
#7
5200
#6
FHD
#5
PCP
#4
DOV
#3 #2
CRG
#1
VGR
#0
G84
[Data type] Bit
G84 Method for specifying rigid tapping
0 : An M code specifying the rigid tapping mode is specified prior to the
issue of the G84 (or G74) command. (See parameter No.5210).
1 : An M code specifying the rigid tapping mode is not used. (G84
cannot be used as a G code for the tapping cycle; G74 cannot be used
for the reverse tapping cycle.)
VGR Any gear ratio between spindle and position coder in rigid tapping
0 : Not used (The gear ratio is set in parameter No.3706.)
1 : Used (The gear ratio is set by parameters Nos. 5221 through 5224 and
5231 through 5234.)
CRG Rigid mode when a rigid mode cancel command is specified (G80, G01
group G code, reset, etc.)
0 : Canceled after rigid tapping signal RGTAP is set to 0.
1 : Canceled before rigid tapping signal RGTAP is set to 0.
DOV Override during extraction in rigid tapping
0 : Invalidated
1 : Validated (The override value is set in parameter No.5211.)
PCP Rigid tapping
0 : Used as a highspeed peck tapping cycle
1 : Not used as a highspeed peck tapping cycle
FHD Feed hold and single block in rigid tapping
0 : Invalidated
1 : Validated
#7
5201
#6 #5 #4
OV3
#3
OVU
#2
TDR
#1 #0
[Data type] Bit
TDR Cutting time constant in rigid tapping
0 : Uses a same parameter during cutting and extraction (Parameter Nos.
5261 through 5264)
1 : Not use a same parameter during cutting and extraction
Parameter Nos. 5261 to 5264: Time constant during cutting
Parameter Nos. 5271 to 5274: Time constant during extraction
OVU The increment unit of the override parameter (No.5211) for tool rigid
tapping extraction is:
0 :
1%
1 : 10%
OV3 The spindle speed for tool extraction is specified by program. Overriding
based on this spindle speed is:
0 : Disabled.
1 : Enabled.
4.20
PARAMETERS OF
RIGID TAPPING

Leave a Reply

Your email address will not be published. Required fields are marked *