PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
8
NOTE
1 The bits left blank in 4. DESCRIPTION OF PARAMETERS
and parameter numbers that appear on the display but are
not found in the parameter list are reserved for future
expansion. They must always be 0.
2 Parameters having different meanings between the Power
Mate iD and Power Mate iH and parameters that are valid
only for the T or M series are indicated in two levels as shown
below. Parameters left blank are unavailable.
Example1
IPR and ISC represent parameters common to the Power
Mate iD and Power Mate iH, and ISA represents a
parameter specific to the Power Mate iH.
Example2
The example below indicates that the parameter is specific
to the Power Mate iD only.
1004
PMiD
PMiH
#7
IPR
#6 #5 #4 #3 #2 #1
ISC
#0
IPR ISC ISA
3736
Maximum clamp speed of the spindle motor
PMiD
PMiH

Leave a Reply

Your email address will not be published. Required fields are marked *