PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
145
6080 M code that calls the custom macro of program number 9020
6081 M code that calls the custom macro of program number 9021
6082 M code that calls the custom macro of program number 9022
6083 M code that calls the custom macro of program number 9023
6084 M code that calls the custom macro of program number 9024
6085 M code that calls the custom macro of program number 9025
6086 M code that calls the custom macro of program number 9026
6087 M code that calls the custom macro of program number 9027
6088 M code that calls the custom macro of program number 9028
6089 M code that calls the custom macro of program number 9029
[Data type] 2word
[Valid data range] 1 to 99999999
These parameters set the M codes that call the custom macros of program
numbers 9020 through 9029.
NOTE
Setting value 0 is invalid. No custom macro can be called by
M00.
6090 ASCII code that calls the subprogram of program number 9004
6091 ASCII code that calls the subprogram of program number 9005
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
[Data type] Byte
[Valid data range] 65 (A:41H) to 90 (Z:5AH)
These parameters set the ASCII codes that call subprograms in decimal.
Addresses that can be used are as follows:
A, B, D, F, H, I, J, K, L, M, P, Q, R, S, T, X, Y, Z
NOTE
Set 0 when no subprogram is called

Leave a Reply

Your email address will not be published. Required fields are marked *