PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
152
0 : The skip signal corresponding to the bit is disabled.
1 : The skip signal corresponding to the bit is enabled.
Multistep skip function
Command
Input
signal
G31
G31P1
G04Q1
G31P2
G04Q2
G31P3
G04Q3
G31P4
G04Q4
G04
G04Q1
G04Q2
G04Q3
G04Q4
SKIP 1S1 2S1 3S1 4S1 DS1
SKIP2 1S2 2S2 3S2 4S2 DS2
SKIP3 1S3 2S3 3S3 4S3 DS3
SKIP4 1S4 2S4 3S4 4S4 DS4
#7
6209
#6 #5 #4 #3 #2 #1 #0
DSK
[Data type] Bit
DSK 0 : Disables skip signal SKIPP from the PMC for the dwell skip function.
1 : Enables skip signal SKIPP from the PMC for the dwell skip function.
6210
Size of buffer 1 (system variable 9000 to 9099)
6211
Size of buffer 2 (system variable 9100 to 9199)
6212
Size of buffer 3 (system variable 9200 to 9299)
6213
Size of buffer 4 (system variable 9300 to 9399)
6214
Size of buffer 5 (system variable 9400 to 9499)
6215
Size of buffer 6 (system variable 9500 to 9599)
6216
Size of buffer 7 (system variable 9600 to 9699)
6217
Size of buffer 8 (system variable 9700 to 9799)
[Data type] Word
[Valid data range] 1 to 100
Specify the size of a buffer for storing the data that is measured with the
highspeed skip signalbased measurement function. (This buffer is a
ring buffer.)
If a value out of the valid data range is specified for a parameter, the
parameter is invalid.

Leave a Reply

Your email address will not be published. Required fields are marked *