PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
10
#7
RMVx0012
#6 #5 #4 #3 #2 #1 #0
MIRx
The following parameter can be set at Setting screen.
[Data type] Bit axis
MIRx Mirror image for each axis
0 : Mirror image is off.
1 : Mirror image is on.
RMVx Releasing the assignment of the control axis for each axis
0 : Not released
1 : Released
NOTE
RMVx is valid when RMBx in parameter 1005#7 is 1.
0020 I/O CHANNEL: Selection of an input/output device
The following parameter can be set at Setting screen.
[Data type] Byte
[Valid data range] 0 to 2, 4, 6, 7, 20 to 35
The CNC provides the following interfaces for data transfer to and from
the host computer and external input/output devices:
F Input/output device interface (RS232C serial port 1 or 2)
This parameter selects the interface used to transfer data to and from an
input/output device.
Setting Description
0, 1 RS232C serial port 1
2 RS232C serial port 2
4 Memory card Interface (on the main unit side)
6 DNC1/Ethernet (for DNC operation only)
7 Memory card interface (on the touch panel side)
20
to
35
Data input/output with the Power Mate in group 0 through an I/O Link
to
Data input/output with the Power Mate in group 15 through an I/O Link

Leave a Reply

Your email address will not be published. Required fields are marked *