PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
157
#7
NCT6700
#6 #5 #4 #3 #2 #1 #0
PCM
[Data type] Bit
PCM M code that counts the total number of machined parts and the number of
machined parts
0 : M02, or M30, or an M code specified by parameter No.6710
1 : Only M code specified by parameter No.6710
NCT 0 : Displays the operating time and the number of parts.
1 : Does not display the operating time and the number of parts.
6710
M code that counts the total number of machined parts and the number of ma-
chined parts
[Data type] Byte
[Valid data range] 0 to 255 except 98 and 99
The total number of machined parts and the number of machined parts are
counted (+1) when the M code set is executed.
NOTE
Set value 0 is invalid (the number of parts is not counted for
M00). Data 98 and 99 cannot be set.
6711 Number of machined parts
This parameter can be set at Setting screen.
[Data type] 2word
[Unit of data] One piece
[Valid data range] 0 to 99999999
The number of machined parts is counted (+1) together with the total
number of machined parts when the M02, M30, or a M code specified by
parameter No.6710 is executed.
NOTE
The number of parts is not counted for M02, M03, when bit
0 (PCM) of parameter No. 6700 is set to 1.
4.29
PARAMETERS OF
DISPLAYING
OPERATION TIME
AND NUMBER OF
PARTS

Leave a Reply

Your email address will not be published. Required fields are marked *