PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
11
NOTE
1 An input/output device can also be selected using the setting screen. Usually, the setting screen
is used.
2 The specifications (such as the baud rate and the number of stop bits) of the input/output
devices to be connected must be set in the corresponding parameters for each interface
beforehand. (See Section 4.2.) I/O CHANNEL = 0 and I/O CHANNEL = 1 represent input/output
devices connected to RS232C serial port 1. Separate parameters for the baud rate, stop bits,
and other specifications are provided for each channel.
3 The input/output unit interface may be referred to as the reader/punch interface.
RS232C serial port 1 and RS232C serial port 2 are also referred to as channel 1 and channel
2, respectively.
4 Channel 2 has no control line, so that the Handy File and Floppy Cassette cannot be connected.
Power Mate i
RS232C serial port 1/2
R232 (JD42A)
I/O CHANNEL=0, 1
(Channel 1)
I/O CHANNEL=2
(Channel 2)
RS-232-C I/O device
RS-232-C I/O device

Leave a Reply

Your email address will not be published. Required fields are marked *