PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
171
OPERATORS PANEL O1234 N5678
SIGNAL1 : OFF ON
SIGNAL2 : OFF ON
SIGNAL3 : OFF ON
SIGNAL4 : OFF ON
SIGNAL5 : OFF ON
SIGNAL6 : OFF ON
SIGNAL7 : OFF ON
SIGNAL8 : OFF ON
These names are set using character codes that are displayed in parameter
Nos. 7220 to 7283.
Parameter No.7220:
Sets the character code (083) corresponding to S of SIGNAL 1.
Parameter No.7221:
Sets the character code (073) corresponding to I of SIGNAL 1.
Parameter No.7222:
Sets the character code (071) corresponding to G of SIGNAL 1.
Parameter No.7223:
Sets the character code (078) corresponding to N of SIGNAL 1.
Parameter No.7224:
Sets the character code (065) corresponding to A of SIGNAL 1.
Parameter No.7225:
Sets the character code (076) corresponding to L of SIGNAL 1.
Parameter No.7226:
Sets the character code (032) corresponding to (space) of SIGNAL 1.
Parameter No.7227:
Sets the character code (049) corresponding to 1 of SIGNAL 1.
Parameter Nos. 7228 to 7235:
Set the character codes of SIGNAL 2 shown in the figure above.
Parameter Nos. 7236 to 7243:
Set the character codes of SIGNAL 3 shown in the figure above.
Parameter Nos. 7244 to 7251:
Set the character codes of SIGNAL 4 shown in the figure above.
Parameter Nos. 7252 to 7259:
Set the character codes of SIGNAL 5 shown in the figure above.
Parameter Nos. 7260 to 7267:
Set the character codes of SIGNAL 6 shown in the figure above.
Parameter Nos. 7268 to 7275:
Set the character codes of SIGNAL 7 shown in the figure above.
Parameter Nos. 7276 to 7283:
Set the character codes of SIGNAL 8 shown in the figure above.
The character codes are shown in Appendix 1 CHARACTER CODE
LIST.
Example
These parameters set the
names of the
generalpurpose switches
(SIGNAL 1 through
SIGNAL 8) on the
software operators panel
as described below.

Leave a Reply

Your email address will not be published. Required fields are marked *