PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
175
#7
FR28002
#6
FR1
#5
PF2
#4
PF1
#3
F10
#2
SUE
#1
DWE
#0
RPD
[Data type] Bit
RPD Rapid traverse rate for PMCcontrolled axes
0 : Feedrate specified with parameter No.1420
1 : Feedrate specified with the feedrate data in an axis control command
DWE Minimum time which can be specified in a dwell command in PMC axis
control when the increment system is ISC
0 : 1 ms
1 : 0.1 ms
NOTE
This parameter is valid when bit 7 (EA2) of parameter
No.8003 is set to 0.
SUE Whether acceleration/deceleration is performed for an axis that is
synchronized with external pulses, for external pulse synchronization
commands in PMC axis control
0 : Performed (exponential acceleration/deceleration)
1 : Not performed
F10 Least increment for the feedrate for cutting feed (per minute) in PMC axis
control
F10 Millimeter input Inch input
0 1 mm/min 0.01 inch/min
1 10 mm/min 0.1 inch/min
PF1, PF2 Set the the feedrate unit of feed per minute in PMC axis control
PF2 PF1 Feedrate unit
0 0 1/1
0 1 1/10
1 0 1/100
1 1 1/1000
FR1, FR2 Set the feedrate unit for feed per rotation for an axis controlled by the
PMC.
FR2 FR1 Millimeter input Inch input
0 0
1 1
0.0001 mm/rev 0.000001 inch/rev
0 1 0.001 mm/rev 0.00001 inch/rev
1 0 0.01 mm/rev 0.0001 inch/rev

Leave a Reply

Your email address will not be published. Required fields are marked *