PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
176
#7
8003
#6 #5 #4 #3 #2 #1 #0
PIM
PIMEA2
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
[Data type] Bit
PIM When only the axes controlled by the PMC are used, the linear axis is:
0: Influenced by inch/millimeter input.
1: Not influenced by inch/millimeter input.
EA2 PMC axis control complies to:
0: Conventional specification
1: New specification (this setting is to be used only when the
multiplepath control function is used.)
NOTE
This parameter is valid when bit 7 (EA2) of parameter
No.8003 is set to 0.
#7
8004
#6
NCI
#5
DSL
#4 #3 #2
JFM
#1
NMT
#0
CMV
[Data type] Bit
CMV When a move command and auxiliary function are specified from the
CNC, and the system is awaiting the auxiliary function completion signal
after completion of the specified axis movement:
0 : An alarm (No.130) is issued when an axis control command is issued
from the PMC for the same axis.
1 : An axis control command, when issued from the PMC for the same
axis, is executed.
NMT When a command is specified from the CNC for the axis on which the tool
is moving according to axis control specification from the PMC:
0 : P/S alarm No.130 is issued.
1 : The command is executed without issuing an alarm, provided the
command does not involve a movement on the axis.
JFM This parameter sets the units used to specify feedrate data when
continuous feed is specified in axis control by the PMC.
Increment
system
JFM Millimeter input Inch input Rotation axis
0 10 mm/min 0.1 inch/min 0.0023 min
1
ISA
1 2000 mm/min 20.0 inch/min 0.46 min
1
0 1 mm/min 0.01 inch/min 0.00023 min
1
ISB
1 200 mm/min 2.00 inch/min 0.046 min
1
0 0.1 mm/min 0.001 inch/min 0.000023 min
1
ISC
1 20 mm/min 0.200 inch/min 0.0046 min
1

Leave a Reply

Your email address will not be published. Required fields are marked *