PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
192
#7
E088500
#6
E07
#5
E06
#4
E05
#3
E04
#2
E03
#1
E02
#0
E01
E168501 E15 E14 E13 E12 E11 E10 E09
[Data type] Bit
E01 to E16 The corresponding highspeed position switch is:
0 : Enabled.
1 : Disabled. (The output of the highspeed position switch signal is
always kept at 0.)
These parameters specify whether to enable or disable the corresponding
highspeed position switches.
A disabled highspeed position switch always outputs 0.
The twodigit number in each parameter name represents the sequence of
the highspeed position switch.
(Example: E01 ––– setting for the first highspeed position switch. E16
––– setting for the sixteenth highspeed position switch.)
#7
D088504
#6
D07
#5
D06
#4
D05
#3
D04
#2
D03
#1
D02
#0
D01
D168505 D15 D14 D13 D12 D11 D10 D09
[Data type] Bit
D01 to D16 The output type of the corresponding highspeed position switch is:
0 : Normal. (The machine coordinate range is used to determine whether
to output the signal.)
1 : Decision by direction. (The machine coordinates and operation
direction are used to determine whether to output the signal.)
These parameters set the output types for the corresponding highspeed
position switches.
The twodigit number in each parameter name represents the sequence of
the highspeed position switch.
(Example: D01 ––– setting for the first highspeed position switch. D16
––– setting for the sixteenth highspeed position switch.)
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
4.41
PARAMETERS OF
HIGHSPEED
POSITION SWITCHES

Leave a Reply

Your email address will not be published. Required fields are marked *