PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
14
#7
NFD0101
#6 #5 #4 #3
ASI
#2 #1 #0
SB2
[Data type] Bit type
SB2 The number of stop bits
0 : 1
1 : 2
ASI Code used at data input
0 : EIA or ISO code (automatically distinguished)
1 : ASCII code
NFD Feed before and after the data at data output
0 : Output
1 : Not output
NOTE
When input/output devices other than the FANUC PPR
are used, set NFD to 1.
0102 Number specified for the input/output device (when the I/O CHANNEL is set to 0)
[Data type] Byte
Set the number specified for the input/output device used when the I/O
CHANNEL is set to 0, with one of the set values listed in Table 4.2.2 (a).
Table 4.2.2 (a) Set value and Input/Output Device
Set value
Input/output device
0 RS232C (Used control codes DC1 to DC4)
1 FANUC CASSETTE ADAPTOR 1 (FANUC CASSETTE B1/ B2)
2 FANUC CASSETTE ADAPTOR 3 (FANUC CASSETTE F1)
3 FANUC PROGRAM FILE Mate,
FANUC FLOPPY CASSETTE ADAPTOR, FANUC Handy File
FANUC SYSTEM P-MODEL H
5 Portable tape reader
6 FANUC PPR
FANUC SYSTEM P-MODEL G, FANUC SYSTEM P-MODEL H
0103 Baud rate (when the I/O CHANNEL is set to 0)
[Data type] Byte
Set baud rate of the input/output device used when the I/O CHANNEL is
set to 0, with a set value in Table 4.2.2 (b).
Table 4.2.2 (b)
Set value
Baud rate (bps)
7 600
8 1200
9 2400
10 4800
11 9600
12 19200
4.2.2
Parameters of
Channel 1
(I/O CHANNEL=0)

Leave a Reply

Your email address will not be published. Required fields are marked *