PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
201
#7
8650
#6 #5 #4 #3 #2 #1
CNA
#0
RSK
[Data type] Bit
RSK When the RESET key is pressed, the key code is:
0 : Not passed to the application.
1 : Passed to the application.
CNA When an NC alarm is issued during the display of the user screen for the C
executor:
0 : The NC alarm screen can be displayed depending on the setting of bit
7 (NPA) of parameter No.3111.
1 : The NC alarm screen is not displayed.
NOTE
This parameter is used with the C executor. Any modifications
to the value set for this parameter does not become effective
until after the system is next powered on.
#7
8653
#6 #5 #4 #3 #2
CM3
#1
CM2
#0
CM1
[Data type] Bit
CM1 The C executor screen defined as CRT_USR_AUX when the [CUSTOM/
GRAPH] key is pressed is:
0 : Not displayed.
1 : Displayed.
CM2 The C executor screen defined as CRT_USR_MCR when the [CUSTOM/
GRAPH] key is pressed is:
0 : Not displayed.
1 : Displayed.
CM3 The C executor screen defined as CRT_USR_MENU when the [CUSTOM/
GRAPH] key is pressed is:
0 : Not displayed.
1 : Displayed.
The following table lists the correspondence between the parameters and
screens.
Parameter Symbol
CM1 CRT_USR_AUX
CM2 CRT_USR_MCR
CM3 CRT_USR_MENU
The symbols in the above table mean the following:
D CRT_USR_AUX screen: Screen displayed when the [CUSTOM/
GRAPH] key is pressed once.
D CRT_USR_MCR screen: Screen displayed when the [CUSTOM/
GRAPH] key is pressed twice.
4.42
OTHER
PARAMETERS

Leave a Reply

Your email address will not be published. Required fields are marked *