PDF Fanuc Power Mate i-D/H Parameter Manual

Replace the description of parameter No.8653 in the chapter “4.31 OTHER PARAMETERS”
of “4. DESCRIPTION OF PARAMETERS” with the contents of the following explanation.
(“NOTE 2” is added)
#7 #6 #5 #4 #3 #2 #1 #0
8653 CM3
CM2
CM1
[Data type] Bit
CM1 When the [CUSTOM/GRAPH] key(NOTE 2) is pushed,
the user screen that was defined as CRT_USR_AUX is
0: not displayed.
1: displayed.
CM2 When the [CUSTOM/GRAPH] key(NOTE 2) is pushed,
the user screen that was defined as CRT_USR_MCR is
0: not displayed.
1: displayed
CM3 When the [CUSTOM/GRAPH] key(NOTE 2) is pushed,
the user screen that was defined as CRT_USR_MENU is
0: not displayed.
1: displayed.
Symbols in a source file set which user screen is displayed.
The following table shows relation between symbols and parameters.
Paramete
r
s
y
mbols
CM1 CRT USR AUX
CM2 CRT_USR_MCR
CM3 CRT_USR_MENU
The symbols mean following screens.
CRT_USR_AUX: a screen displayed with a push of [CUSTOM/GRAPH] key.
CRT_USR_MCR: a screen displayed with twice push of [CUSTOM/GRAPH] key.
CRT_USR_MENU: a screen displayed with three times push
of [CUSTOM/GRAPH] key.
These screens are changed with a push of [CUSTOM/GRAPH] key.
The screens, whose parameter is set to “0” are skipped.
(NOTE)
1. When the Macro Executor option is effective, these parameters are invalid.
2. The virtual-key to switch to FANUC PICTURE screen can be assigned by the parameter
3195#0, when the LCD unit with touch panel is used.
B-63180EN/02-5
3/3
EDIT
DATE DESIG. DESCRIPTION
FANUC Power Mate i-MODEL D/H
The assignment of the virtual-key to switch to FANUC
PICTURE screen when the LCD unit with touch panel is used
TITLE
DRAW.NO. CUST.
SHEET
01 02.05.06
Newly added

Leave a Reply

Your email address will not be published. Required fields are marked *