PDF Fanuc Power Mate i-D/H Parameter Manual

FANUC Power Mate i - MODEL D/H
CNC screen display function
TITLE
Please add the following explanations in chapter of “4.14 PARAMETERS OF MDI,
DISPLAY, AND EDIT.”
No.
# 7 # 6 # 5 # 4 # 3 # 2 # 1 # 0
3103
NCSNC
[Data type] Bit
NCSNC When a C language executor screen is displayed , CNC screen display function is
0: enabled to start or stop.
1: disabled to start or stop.
NOTE
1. When “1” is set and a C language executor screen is displayed, the messages of
“CNC refused the start of the CNC screen display function.” in starting and “Please
exit from the C-EXE screen.” in stopping are displayed in POPUP windows on PC.
2. If CNC screen display function cannot start and stop when you set “0”,
it is necessary to recompile programs of screens that is designed by C language
executor with library that supports CNC screen function and is provided from
FANUC.
No
# 7
# 6 # 5 # 4 # 3 # 2 # 1 # 0
3206 NS2 S2K
[Data type] Bit
NS2 Dual screen of CNC screen display function
0: is not used.
1: is used.
NOTE
1. In case “0” is set, single screen of CNC screen display function is effective as
CNC screen display function.
2. If you needs to display macro executor or C language executor screens on PC
screen, please set “1”.
B-63180EN/02-09
2 / 3 EDIT
DATE DESIG. DESCRIPTION
DRAW.NO.
CUST.
SHEET

Leave a Reply

Your email address will not be published. Required fields are marked *