PDF Fanuc Power Mate i-D/H Parameter Manual

Add the following description to 4. Description of Parameters.
8691
Top number of sub-program number
[Data type] 2-word
[Valid data range] 1 to 9999 In case program number O4 digits
1 to 99999999 In case program number O8 digits
But 8000 to 8031 assigned to main program can not be specified.
Note
When this parameter is set, the power must be turned off before
operation is continued.
Also be sure to recompile programs after the power on.
8692
Total number of sub-program
[Data type] Word
[Valid data range] 1 to 250
Note
1. When this parameter is set, the power must be turned off before
operation is continued.
Also be sure to recompile programs after the power on.
2. Part program storage is required for making program. Registered total
program number included in basic function is 63. So specify enough
capacity of part program storage and total program number according
to your program.
3. The area that includes main program number (O8000 to O8031) can not
be specified as the area of sub-program. If such is set, sub-program
calling function can not be used.
Ex) The following setting (Specify O7900 to O8099 as sub-program
number) is forbidden.
Parameter No. 8691 = 7900
Parameter No. 8692 = 200
4. When these parameter, No.8691 and No.8692, is not set correctly,
sub-program calling function can not be used.
Main programs and sub-programs are protected from editing/displaying by
setting the following parameters.
Parameter No.3202#0(NE8),#4(NE9), parameter No.3204#3(P8E),#4(P9E)
In case sub-program numbers are within 8032 to 8999
(The area of sub-program number is specified by the parameter
No.8691 and No.8692)
If NE8=1, a compile error 1824 occurs at compiling.
In case sub-program numbers are within 8032 to 9999.
EDIT
DATE DISIGNE
DESCRIPTION
TITLE
DRAW
FANUC Power Mate i - MODEL H
Sub program call for high-speed
response function
B-63180EN/02-11
SHEET
2/3
APPROV.
FANUC LTD
01 020621 New design
If NE8=1 and NE9=1, a compile error 1824 occurs at compiling.

Leave a Reply

Your email address will not be published. Required fields are marked *