PDF Fanuc Power Mate i-D/H Parameter Manual

Date February 2003.
General Manager of
Software Laboratory
FANUC Power Mate i – MODEL D/H
The function of feedrate override and feedrate override cancel for each axis group in the PMC axis control
TECHNICAL REPORT
(
MANUAL
)
No. TMN 03
0012E
1. Communicate this report to:
Your information
GE Fanuc-N, GE Fanuc-E
FANUC Robotics
MILACRON
Machine tool builder
Sales agency
End user
2.Summary for Sales Document (Sales guide, Functional comparison list etc.)
Feedrate override and feedrate override cancel for each axis group function can be used
in the PMC axis control.
3.Notice
Nothing
4.Attached Document
Drawing
No.
B-63173EN-1/01-42 (1/5~5/5)
B-63180EN/02-12 (1/2~2/2)
5.Registration of Order List data (In case of Order List)
Type of data
Lotus 123/WinOasys
Original section of issue
EAO Senior manager Supervisor

Leave a Reply

Your email address will not be published. Required fields are marked *