PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
20
CAUTION
The following parameters are valid only if the DPL/MDI
Operation Package is used as a display unit.
If the CRT/MDI is in use, make the necessary settings using
the Ethernet Parameter screen.
0704 First part of the IP address of the NC
0705 Second part of the IP address of the NC
0706 Third part of the IP address of the NC
0707 Fourth part of the IP address of the NC
[Data type] Byte
[Valid data range] 0 to 255
Specify the IP address of the NC, using four parameters.
Supposing the NC has IP address 192.168.0.1, the four parts of the IP
address are specified as follows:
First part: 192
Second part: 168
Third part: 0
Fourth part: 1
Specify them in the respective parameters.
0712 First part of the IP address mask address of the network
0713 Second part of the IP address mask address of the network
0714 Third part of the IP address mask address of the network
0715 Fourth part of the IP address mask address of the network
[Data type] Byte
[Valid data range] 0 to 255
Specify the IP address mask address of the network, using four
parameters.
Supposing the NC has IP address 255.254.253.0, the four parts of the IP
address are specified as follows:
First part: 255
Second part: 254
Third part: 253
Fourth part: 0
Specify them in the respective parameters.
4.5
PARAMETERS OF
ETHERNET

Leave a Reply

Your email address will not be published. Required fields are marked *