PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
21
0720 First part of the IP address of the router
0721 Second part of the IP address of the router
0722 Third part of the IP address of the router
0723 Fourth part of the IP address of the router
[Data type] Byte
[Valid data range] 0 to 255
Specify the IP address of the router, using four parameters.
Supposing IP address 192.168.0.99, the four parts of the IP address are
specified as follows:
First part: 192
Second part: 168
Third part: 0
Fourth part: 99
Specify them in the respective parameters.
0724 Port number for TCP
[Data type] Twoword
[Valid data range] 5001 to 65535
Specify the port number to be used with the DNC1/Ethernet function.
This port number must match the NC IP address in the Machine
Configuration dialog box on the PC.
Refer to FANUC Personal Computer FA System Operators Manual for
explanations about what value to specify.
0725 Port number for UDP
[Data type] Twoword
[Valid data range] 5001 to 65535
Specify the port number to be used with the DNC1/Ethernet function.
This port number must match FANUC_C4_SERVER in the services
file on the PC.
Refer to FANUC Personal Computer FA System Operators Manual for
explanations about what value to specify.
0726 Time interval
[Data type] Twoword
[Unit of data] 10 ms
[Valid data range] 0 to 65535
Specify the interval at which broadcasts are to be sent.
0 to 9 : No broadcast will be sent. An interval shorter than 100 ms
cannot be specified.

Leave a Reply

Your email address will not be published. Required fields are marked *