PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
22
#7
0727
#6 #5 #4 #3 #2 #1
RIP
#0
TRN
[Data type] Bit
TRN If the DPL/MDI Operation Package is in use, setting this parameter to 1
causes the Ethernet parameters to be sent to the Ethernet board. The
parameter also indicates the result of the parameter transfer attempt as
follows:
0 : The Ethernet board did not accept them.
1 : The Ethernet board accepted them.
NOTE
When any parameter between parameter No. 704 and
parameter No. 726 is set, this parameter becomes 0. If this
parameter becomes 1, data is sent to the Ethernet board.
This parameter remains set to 1 if the Ethernet board
accepts the parameters. Otherwise, it becomes 0.
If it is 0, reset the parameters and rerun.
RIP If the DPL/MDI Operation Package is in use, router IP address selection is:
0 : Disabled.
1 : Enabled.
If disabled, the values of parameter Nos. 720 to 723 will not be sent to the
Ethernet board.

Leave a Reply

Your email address will not be published. Required fields are marked *