PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
33
1240
Coordinate value of the reference position on each axis in the machine
coordinate system
NOTE
When this parameter is set, power must be turned off before
operation is continued.
1241
Coordinate value of the second reference position on each axis in the machine
coordinate system
1242
Coordinate value of the third reference position on each axis in the machine coor-
dinate system
[Data type] 2word axis
[Unit of data]
Increment system ISA ISB ISC Unit
Millimeter machine 0.01 0.001 0.0001
mm
Inch machine 0.001 0.0001 0.00001
inch
Rotation axis 0.01 0.001 0.0001
deg
[Valid data range] 99999999 to 99999999
Set the coordinate values of the reference positions in the machine
coordinate system.
1250
Coordinate value of the reference position used when automatic coordinate sys-
tem setting is performed
[Data type] 2word axis
[Unit of data]
Input increment ISA ISB ISC Unit
Linear axis (input in mm) 0.01 0.001 0.0001 mm
Linear axis (input in inches) 0.001 0.0001 0.00001 inch
Rotation axis 0.01 0.001 0.0001 deg
[Valid data range] 99999999 to 99999999
Set the coordinate value of the reference position on each axis to be used
for setting a coordinate system automatically.
1251
Coordinate value of the reference position on each axis used for setting a coordi-
nate system automatically when input is performed in inches
[Data type] 2word axis
[Unit of data]
Incerment system ISA ISB ISC Unit
Linear axis (input in inches) 0.001 0.0001 0.00001 inch
[Valid data range] 99999999 to 99999999
Set the coordinate value of the reference position on each axis to be used
for setting a coordinate system automatically when input is performed in
inches.

Leave a Reply

Your email address will not be published. Required fields are marked *